CLICK HERE: Teacher Training Video
POWER/MUTE SWITCH: Press and hold to power on, press to mute, press and hold to power off.
- MIC 1 STATUS: lighted to indicate microphone is registered as MIC 1 • Blue: solid = normal operation; Blue: flashing = linking in progress • Red: solid = muted; Red: flashing = muted while linking in progress
- MIC 2 STATUS: when using a second microphone, this LED is lighted to indicate microphone is registered as MIC 2 (same behavior as MIC 1 status light above)
CHARGING/LOW BATTERY INDICATOR: lights red when charging, green when fully charged. When in operation, turns red to indicate low battery.
IN USE solid blue = paired flashing blue = pairing solid red = muted CHARGING red = charging or needs charged green = fully charged
Hazel Dell TA Only:
- For Pairing a NEW mic to a system with an ALREADY PAIRED mic follow this link: https://www.youtube.com/watch?v=PC5lStQjUQI
- For Pairing a NEW mic to a system WITHOUT and existing mic follow this link: https://www.youtube.com/watch?v=WmgCh5WmbWU&t=53s
----------------------------------------------------------------------------------------------------------------------------------------------------
SOFTWARE UPDATE INSTRUCTIONS FOR BUILDING TA's:
Below and attached is the information regarding software upgrades for
your Lightspeed system that should ensure proper functioning of the
system.
Here is a helpful video: https://www.youtube.
This is the link to the update app: https://app.tara.
May not work in Firefox – Use Chrome when possible.
If you are on a PC, there is a driver that needs to be downloaded from the App
- Have all Lightspeed components turned on and paired up. Extra mics are OK to be left in the chargers during an update
- Connect your computer to the device being updated (usually an FMN Flexmike)
- Log in using your email address
- Enter code from your email
- Click the blue “Detect System” bar
- If the dialog box does not appear, reconnect the device and click the blue bar again
- Follow the prompts
- When done running the updates, click on “Disconnect” at the bottom of the page
- Cycle the power on the device
- Reconnect to verify update complete